The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front drive shaft oil seal LH and front drive shaft oil seal RH removal/installation are shown below.
53737B
1.REMOVE FRONT FENDER APRON SEAL LH
2.DRAIN AUTOMATIC TRANSAXLE FLUID
Remove the refill plug and gasket from the rear transaxle cover sub-assembly.
Using a 6 mm hexagon socket wrench, remove the overflow plug and gasket from the automatic transaxle oil pan sub-assembly.
| *1 | No. 1 Transmission Oil Filler Tube |
Using a 6 mm hexagon socket wrench, remove the No. 1 transmission oil filler tube from the automatic transaxle oil pan sub-assembly.
Drain automatic transaxle fluid from the automatic transaxle assembly.
Using a 6 mm hexagon socket wrench, install the No. 1 transmission oil filler tube to the automatic transaxle oil pan sub-assembly.
Using a 6 mm hexagon socket wrench, temporarily install the gasket and overflow plug to the automatic transaxle oil pan sub-assembly.
Reuse the old gasket as the overflow plug will be removed again to adjust the automatic transaxle fluid level.
Temporarily install the gasket and refill plug to avoid automatic transaxle fluid spillage.
Reuse the old gasket as the refill plug will be removed again to adjust the automatic transaxle fluid level.
3.REMOVE FRONT DRIVE SHAFT ASSEMBLY
43457
4.REMOVE DRIVE SHAFT BEARING BRACKET
43420H
5.REMOVE FRONT DRIVE SHAFT OIL SEAL LH
Using SST, remove the front drive shaft oil seal LH from the transaxle case sub-assembly.
Be careful not to damage the transaxle case sub-assembly.
43410M
6.REMOVE FRONT DRIVE SHAFT OIL SEAL RH
Using SST, remove the front drive shaft oil seal RH from the transaxle housing.
Be careful not to damage the transaxle housing.
43410M
7.INSTALL FRONT DRIVE SHAFT OIL SEAL RH
| *a | Depth |
Using SST and a hammer, install a new front drive shaft oil seal RH to the transaxle housing.
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
Make sure that the front drive shaft oil seal RH is installed in the correct direction.
Do not damage the lip of the front drive shaft oil seal RH.
43420H
8.INSTALL FRONT DRIVE SHAFT OIL SEAL LH
| *a | Depth |
Using SST and a hammer, install a new front drive shaft oil seal LH to the transaxle case sub-assembly.
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
Make sure that the front drive shaft oil seal LH is installed in the correct direction.
Do not damage the lip of the front drive shaft oil seal LH.
43457
9.INSTALL DRIVE SHAFT BEARING BRACKET
10.INSTALL FRONT DRIVE SHAFT ASSEMBLY
11.ADJUST AUTOMATIC TRANSAXLE FLUID
12.INSPECT FOR OIL LEAK
53737B
13.INSTALL FRONT FENDER APRON SEAL LH