The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pressure pulsation damper assembly removal/installation are shown below.
Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.
Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.
Sparks could cause vaporized fuel to ignite, resulting in a serious accident.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCHARGE FUEL SYSTEM PRESSURE
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
12601B
4.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
17705
5.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
23901
6.DISCONNECT FUEL TUBE SUB-ASSEMBLY
| *a | Claw |
Disengage the 2 claws to remove the No. 2 fuel pipe clamp.
Disconnect the fuel tube sub-assembly from the fuel delivery pipe.
Disengage the clamp to disconnect the fuel tube sub-assembly from the fuel hose clamp.
23270
7.REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY
Remove the 2 bolts and fuel pressure pulsation damper assembly from the fuel delivery pipe.
Remove the O-ring from the fuel pressure pulsation damper assembly.