The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front stabilizer bar removal/installation are shown below.
1.REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
for 2AR-FE: Click hereEngine / Hybrid System>2AR-FE (ENGINE MECHANICAL)>ENGINE ASSEMBLY>REMOVAL
for A25A-FKS: Click hereEngine / Hybrid System>A25A-FKS (ENGINE MECHANICAL)>ENGINE ASSEMBLY>REMOVAL
for 2GR-FKS: Click hereEngine / Hybrid System>2GR-FKS (ENGINE MECHANICAL)>ENGINE ASSEMBLY>REMOVAL
for 6AR-FSE: Click hereEngine / Hybrid System>6AR-FSE (ENGINE MECHANICAL)>ENGINE ASSEMBLY>REMOVAL
48810
2.REMOVE FRONT STABILIZER LINK ASSEMBLY LH
w/ Cap:
Remove the cap from the nut.
Remove the nut and front stabilizer link assembly LH from the front stabilizer bar.
Do not damage the boot of the ball joint.
If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.
48820B
3.REMOVE FRONT STABILIZER LINK ASSEMBLY RH
Perform the same procedure as for the LH side.
48829A
4.REMOVE FRONT NO. 1 STABILIZER BRACKET LH
| *A | for TMC Made |
| *B | for TMR Made |
Remove the 2 bolts and front No. 1 stabilizer bracket LH from the front frame assembly.
48824A
5.REMOVE FRONT NO. 1 STABILIZER BRACKET RH (for A25A-FKS)
Remove the 2 bolts and front No. 1 stabilizer bracket RH from the front frame assembly.
48824A
6.REMOVE FRONT NO. 1 STABILIZER BRACKET RH (for 2GR-FKS, 2AR-FE, 6AR-FSE)
Perform the same procedure as for the LH side.
48811
7.REMOVE FRONT STABILIZER BAR
Remove the front stabilizer bar with 2 front stabilizer bar bushings from the front frame assembly.
48815
8.REMOVE FRONT NO. 1 STABILIZER BAR BUSHING (for LH Side)
Remove the front No. 1 stabilizer bar bushing from the front stabilizer bar.
48815
9.REMOVE FRONT NO. 1 STABILIZER BAR BUSHING (for RH Side)
Perform the same procedure as for the LH side.