Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HV RELAY ASSEMBLY (for NICKEL METAL HYDRIDE BATTERY)
RM33C0E _51 Engine / Hybrid System _065433 HYBRID / BATTERY CONTROL _0328996 HV RELAY ASSEMBLY(for NICKEL METAL HYDRIDE BATTERY) A

HYBRID / BATTERY CONTROL  HV RELAY ASSEMBLY(for NICKEL METAL HYDRIDE BATTERY)  INSTALLATION  


PROCEDURE

Hide G92Z0 1.INSTALL HV BATTERY JUNCTION BLOCK ASSEMBLY

CAUTION:

Be sure to wear insulated gloves and protective goggles.


a.

Install the HV battery junction block assembly to the HV battery with the 4 nuts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

NOTICE:

If the HV battery junction block assembly has been struck or dropped, replace it with a new one.



b.

Connect the HV battery junction block assembly connector.

NOTICE:

Make sure that the connectors are connected securely.



c.

Engage the 2 claws to install the wiring harness protector.


d.

Connect the HV battery junction block assembly connector.

NOTICE:

Make sure that the connectors are connected securely.



e.

Engage the 2 claws to close the wiring harness protector.


f.

Engage the clamp.


g.

Connect the HV battery junction block assembly connector.

NOTICE:

Make sure that the connectors are connected securely.



h.

Connect the electric vehicle battery plug assembly with the bolt.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


Hide G920NB 2.INSTALL UPPER HV BATTERY COVER SUB-ASSEMBLY

Hide 82161 4.CONNECT FLOOR WIRE

CAUTION:

Be sure to wear insulated gloves.


a.

Engage the 2 clamps to connect the floor wire.


b.

Connect the HV battery junction block assembly connector.


c.

Connect the electric vehicle battery plug assembly connector.


d.

Engage the clamp.


Hide 71033 7.INSTALL REAR SEAT CUSHION LEG SUB-ASSEMBLY

Hide 76974F 9.INSTALL REAR UNDER SIDE COVER LH

Hide 67918A 10.INSTALL REAR DOOR SCUFF PLATE LH

Hide 76973F 11.INSTALL REAR UNDER SIDE COVER RH

Hide 67917A 12.INSTALL REAR DOOR SCUFF PLATE RH

HINT:

Use the same procedure as for the LH side.


Hide 899A0 13.INSTALL NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY