| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0606 | ECM internal error (1 trip detection logic) | ECM |
| P0607 | ECM internal error (1 trip detection logic) | ECM |
After replacing the ECM, the new ECM needs registration (Click here Engine / Hybrid System>N04C-UH (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION) and initialization (Click here Engine / Hybrid System>N04C-UH (ENGINE CONTROL)>ECD SYSTEM>INITIALIZATION).
Clear the DTCs (Click here Engine / Hybrid System>N04C-UH (ENGINE CONTROL)>ECD SYSTEM>DTC CHECK / CLEAR).
Turn the ignition switch off.
Disconnect the negative battery terminal and wait for 1 minute.
Connect the negative battery terminal.
Turn the ignition switch to ON.
Enter the following menus: Powertrain / Engine and ECT / DTC
Read the DTCs.
| Result | Proceed to |
|---|---|
| P0606 and/or P0607 | A |
| No output | B |
A
B
Click hereEngine / Hybrid System>N04C-UH (ENGINE CONTROL)>ECD SYSTEM>CHECK FOR INTERMITTENT PROBLEMS