Home › Engine / Hybrid System › N04C-UH (ENGINE CONTROL) › ECD SYSTEM
RM2850E _51 Engine / Hybrid System _073137 N04C-UH ENGINE CONTROL _0355844 ECD SYSTEM C

N04C-UH ENGINE CONTROL  ECD SYSTEM  P1601  Injector Correction Circuit Malfunction (EEPROM)  


DESCRIPTION

DTC No. DTC Detection Condition Trouble Area
P1601 When either condition below is met:
(1 trip detection logic)
·

Injection compensation code is not registered

·

Incorrect injection compensation code is registered


·

Injector compensation code

·

ECM



NOTICE:
·

When an injector is replaced, the injector compensation code must be input into the ECM.

When the ECM is changed, all of the existing injector compensation codes must be input into the new ECM.

·

Injector compensation codes are unique, 30-digit, alphanumeric values printed on the head portion of each injector. If an incorrect injector compensation code is input into the ECM, the engine assembly may rattle or engine idling may become rough. In addition, engine failure may occur and the life of the engine may be shortened.



When replacing the ECM with a new one, input all the injector compensation codes into the new ECM as follows:


a.

Prior to replacing the ECM, use the intelligent tester to read and save each injector compensation code from the original ECM.


b.

After installing a new ECM, input the saved compensation codes into the new ECM using the tester.


c.

Turn the ignition switch off and then turn the tester off.


d.

Wait for at least 30 seconds.


e.

Turn the ignition switch to ON and then turn the tester on.


f.

Clear DTC P1601 stored in the ECM using the tester (Click here Engine / Hybrid System>N04C-UH (ENGINE CONTROL)>ECD SYSTEM>DTC CHECK / CLEAR).

HINT:
·

Each injector has different fuel injection characteristics. In order to optimize the fuel injections, the ECM uses the compensation codes to balance the different fuel injections between each injector.

·

When you first turn the ignition switch to ON after replacing the ECM or an injector(s), DTC P1601 is set. If an injector was replaced, the compensation code for the new injector will need to be registered in the ECM. If the ECM was replaced, the compensation codes for the injector must be registered to the new ECM. Manually clear the DTCs upon completion of compensation code registration.





CAUTION / NOTICE / HINT

NOTICE:

After replacing the ECM, the new ECM needs registration (Click hereEngine / Hybrid System>N04C-UH (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION) and initialization (Click here Engine / Hybrid System>N04C-UH (ENGINE CONTROL)>ECD SYSTEM>INITIALIZATION).


HINT:

Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.CHECK INJECTOR COMPENSATION CODE
a.

Read the injector compensation code (Click here Engine / Hybrid System>N04C-UH (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION).

OK:

Compensation codes stored in the ECM match compensation codes of the installed injectors.



Result:
Proceed to
OK
NG



OK

NG

PERFORM REGISTRATION INJECTOR COMPENSATION CODE