Home › Engine / Hybrid System › N04C-VQ (FUEL) › FUEL INJECTOR › 2017.01–2019.08
RM2850E _51 Engine / Hybrid System _073145 N04C-VQ FUEL _0355914 FUEL INJECTOR A

N04C-VQ FUEL  FUEL INJECTOR  REMOVAL  


PROCEDURE

Hide 1.CHECK INJECTOR COMPENSATION CODE

HINT:

If the injector compensation code is not correctly registered, it may cause malfunctions.


a.

Read the injector compensation code.


b.

Check that the compensation code of the installed injector is the same as the code registered in the ECM. If the code is not the same, register the injector compensation code on the injector.


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 25608 3.REMOVE EGR COOLER SUB-ASSEMBLY

Hide 12180E 4.REMOVE OIL FILLER CAP SUB-ASSEMBLY

Hide 11201 5.REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY

Hide 11202F 6.REMOVE CYLINDER HEAD COVER CUSHION RUBBER

Hide 11202D 7.REMOVE NO. 2 CYLINDER HEAD COVER SUB-ASSEMBLY

Hide 11228 8.REMOVE CYLINDER HEAD COVER CUSHION

Hide 11213 9.REMOVE CYLINDER HEAD COVER GASKET

Hide 23741B 10.REMOVE INJECTION PIPE CLAMP

Hide 11.REMOVE INJECTION PIPE SUB-ASSEMBLY

Hide 23670 12.REMOVE INJECTOR ASSEMBLY

a.
A101560

Remove the 5 hollow screws and 5 gaskets, and then remove the nozzle leakage pipe assembly.

HINT:

After removing the nozzle leakage pipe assembly, put it in a plastic bag to prevent foreign matter from contaminating the injector assemblies.



b.
A101561

Using a small screwdriver, remove the 4 holder seals.


c.
A101562

Remove the 4 nozzle holder clamp bolts and the 4 nozzle holder clamps.

NOTICE:

Arrange the holder clamps and nozzle holder clamp bolts in the correct order.



d.

Remove the 4 injector assemblies.

NOTICE:

Arrange the injector assemblies in the correct order.



e.
A101564

Attach tags to identify the cylinder (#1 to #4) to the injector assemblies so that each injector assembly can be inserted into the correct cylinder during installation.


f.

Remove the gasket from each injector assembly.


g.
A429711E01
1,0.938 1.167,0.938 1.167,0.938 1.396,1.208 false 0.813,0.844 1.125,1.042 0.313,0.198 10 false *1

Remove the O-ring from each injector assembly.

Text in Illustration
*1 O-Ring


Hide 11177 13.REMOVE INJECTION NOZZLE SEAT GASKET

a.

Remove the 4 injection nozzle seat gaskets from the cylinder head sub-assembly.