1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
25608
2.REMOVE EGR COOLER SUB-ASSEMBLY
12180E
3.REMOVE OIL FILLER CAP SUB-ASSEMBLY
11201
4.REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY
11202F
5.REMOVE CYLINDER HEAD COVER CUSHION RUBBER
11202D
6.REMOVE NO. 2 CYLINDER HEAD COVER SUB-ASSEMBLY
11228
7.REMOVE CYLINDER HEAD COVER CUSHION
11213
8.REMOVE CYLINDER HEAD COVER GASKET
9.SET NO. 1 CYLINDER TO TDC / COMPRESSION
17113D
10.REMOVE NO. 1 INTAKE PIPE
11301K
11.REMOVE CRANKSHAFT POSITION SENSOR
58396E
12.REMOVE WIRE HARNESS CLAMP BRACKET
Disconnect the 3 clamps.
Remove the 2 bolts and disconnect the ground wire and engine wire.
Remove the 2 bolts and 2 wire harness clamp brackets.
Remove the nut and disconnect the engine wire.
Remove the 2 bolts and wire harness clamp bracket.
23802E
13.REMOVE FUEL PIPE SUB-ASSEMBLY
Remove the 4 nuts and 4 fuel pipe clamps.
Remove the 5 union bolts and 8 gaskets.
Disconnect the 2 fuel tubes.
Remove the fuel pipe sub-assembly.
23811
14.REMOVE FUEL FILTER TO INJECTION PUMP FUEL PIPE
Remove the nut and fuel pipe clamp.
Using a 17 mm union nut wrench, loosen the 2 union nuts.
Remove the fuel filter to injection pump fuel pipe.
Be sure to prevent foreign matter or water from entering the lines.
22100
15.REMOVE SUPPLY PUMP ASSEMBLY
Disconnect the 2 connectors.
Remove the nut, 2 bolts, and injection pump stay.
Remove the 4 bolts and the supply pump assembly.
Remove the O-ring from the timer cover.
13613
16.REMOVE INJECTION PUMP DRIVE GEAR
Clamp the injection pump assembly in a vise.
Remove the 2 bolts and the timer cover.
Remove the O-ring from the timer cover.
Remove the nut, injection pump drive gear and crankshaft angle sensor plate.