Use the same procedure for RHD and LHD vehicles.
The procedures listed below are for RHD vehicles.
73210
1.INSTALL FRONT SEAT OUTER BELT ASSEMBLY RH
Attach the 2 guides and temporarily install the front seat outer belt assembly RH.
Install the bolt.
5.0 N*m (51 kgf*cm, 44 in.*lbf)
w/ Pretensioner and Force Limiter:
Connect the pretensioner connector and lock the locking button as shown in the illustration.
Securely lock the locking button.
| *a | Locking Button |
Check that the front seat outer belt assembly RH is not twisted.
Tighten the bolt to connect the shoulder anchor of the front seat outer belt assembly RH.
42 N*m (428 kgf*cm, 31 ft.*lbf)
Attach the 2 claws to close the shoulder anchor cover.
62413A
2.INSTALL LOWER CENTER PILLAR GARNISH RH
62311C
3.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH
62515B
4.INSTALL NO. 1 SIDE TRIM BASE COVER RH
5.CONNECT FRONT SEAT OUTER BELT ASSEMBLY RH
Check that the front seat outer belt assembly RH is not twisted.
Tighten the bolt connect the floor anchor of the front seat outer belt assembly RH with the bolt.
42 N*m (428 kgf*cm, 31 ft.*lbf)
73233
6.INSTALL OUTER LAP BELT ANCHOR COVER
Attach the 3 guides to install the outer lap belt anchor cover.
46243
7.INSTALL PARKING BRAKE LEVER COVER
8.INSTALL FRONT SEAT ASSEMBLY RH
9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Pretensioner and Force Limiter)
10.CHECK SRS WARNING LIGHT (w/ Pretensioner and Force Limiter)
for 2 connectors Type:
for 3 connectors Type: