Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
84140
1.INSTALL HEADLIGHT DIMMER SWITCH ASSEMBLY
If reusing the headlight dimmer switch assembly:
Set the headlight dimmer switch assembly to the steering column.
While loosening the band clamp, attach the claw to install the headlight dimmer switch assembly.
Tighten the band clamp.
Connect the connector.
If replacing a new headlight dimmer switch assembly:
Set the headlight dimmer switch assembly to the steering column.
Attach the claw to install the headlight dimmer switch assembly.
Remove the pin and tighten the band clamp.
Connect the connector.
| *A | If reusing the headlight dimmer switch assembly |
| *B | If replace a new headlight dimmer switch assembly |
|
Pin |
84650
2.INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY
84306
3.INSTALL SPIRAL CABLE SUB-ASSEMBLY (w/ Airbag System)
45286B
4.INSTALL UPPER STEERING COLUMN COVER
45287
5.INSTALL LOWER STEERING COLUMN COVER
45100
6.INSTALL STEERING WHEEL ASSEMBLY
7.INSPECT STEERING WHEEL CENTER POINT
8.INSTALL HORN BUTTON ASSEMBLY (w/ Airbag System)
9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Airbag System)
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
10. PERFORM DIAGNOSTIC SYSTEM CHECK (w/ Airbag System)
11.INSPECT CHECK SRS WARNING LIGHT (w/ Airbag System)
for 2 Connectors Type:
for 3 Connectors Type: