Make sure to release the vacuum from the brake booster before removing the master cylinder from the brake booster.
1. PRECAUTION
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55301
3.REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
4.REMOVE STEERING COLUMN ASSEMBLY
55330B
5.REMOVE INSTRUMENT PANEL REINFORCEMENT ASSEMBLY
55305C
6.REMOVE INSTRUMENT PANEL REINFORCEMENT SUB-ASSEMBLY
Remove the 4 bolts and instrument panel reinforcement sub-assembly.
47201
7.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
8.DISCONNECT NO. 1 CLUTCH BOOSTER VACUUM HOSE
9.DISCONNECT CLUTCH RESERVOIR TUBE
31481K
10.REMOVE MASTER CYLINDER TO TUBE CONNECTOR TUBE
Disconnect the master cylinder to tube connector tube from the clutch master cylinder assembly (Click hereDrivetrain>CLUTCH>CLUTCH MASTER CYLINDER>REMOVAL).
Remove the bolt.
Disconnect the clamp from the master cylinder to tube connector tube.
Disconnect the master cylinder to tube connector tube from the No. 2 brake tube clamp.
Detach the 2 claws and disconnect the master cylinder to tube connector tube from the No. 3 brake tube clamp.
Detach the claw and disconnect the master cylinder to tube connector tube from the No. 3 brake tube clamp.
Using a union nut wrench, disconnect the master cylinder to tube connector tube from the tube connector.
Remove the master cylinder to tube connector tube.
11.REMOVE BRAKE TUBE
Disconnect the 2 brake tubes from the No. 1 brake tube clamp.
Remove the No. 1 brake tube clamp.
Disconnect the 2 brake tubes from the No. 2 brake tube clamp.
Remove the No. 2 brake tube clamp.
Detach the 4 claws and disconnect the 2 brake tubes from the 2 No. 3 brake tube clamps.
Remove the 2 bolts and the 2 No. 3 brake tube clamps.
Detach the 2 claws and disconnect the 2 brake tubes from the No. 3 brake tube clamp.
Remove the bolt and No. 3 brake tube clamp.
Using a union nut wrench, disconnect the 2 brake tubes from the tube connector.
Remove the 2 brake tubes.
12.DISCONNECT VACUUM HOSE ASSEMBLY
Slide the clip and disconnect the vacuum hose assembly.
55106D
13.REMOVE PEDAL BRACKET SUB-ASSEMBLY
Disconnect the clamp from the pedal bracket sub-assembly.
Remove the 5 bolts, 2 nuts and pedal bracket sub-assembly.
44610
14.REMOVE BRAKE BOOSTER ASSEMBLY
Remove the clip and push rod pin.
Remove the 4 nuts and brake booster assembly.
47264D
15.REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS
Loosen the lock nut, remove the master cylinder push rod clevis and lock nut.