Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER (for RHD with Brake pedal Load Sensing Switch) › 2017.01–2021.01
RM2850E _54 Brake _073226 BRAKE SYSTEM (OTHER) _0356462 BRAKE BOOSTER(for RHD with Brake pedal Load Sensing Switch) A

BRAKE SYSTEM (OTHER)  BRAKE BOOSTER(for RHD with Brake pedal Load Sensing Switch)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

Make sure to release the vacuum from the brake booster before removing the master cylinder from the brake booster.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55301 3.REMOVE INSTRUMENT PANEL SUB-ASSEMBLY

Hide 4.REMOVE STEERING COLUMN ASSEMBLY

Hide 55330B 5.REMOVE INSTRUMENT PANEL REINFORCEMENT ASSEMBLY

Hide 55305C 6.REMOVE INSTRUMENT PANEL REINFORCEMENT SUB-ASSEMBLY

a.

Remove the 4 bolts and instrument panel reinforcement sub-assembly.


Hide 47201 7.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

Hide 8.DISCONNECT NO. 1 CLUTCH BOOSTER VACUUM HOSE

Hide 9.DISCONNECT CLUTCH RESERVOIR TUBE

Hide 10.REMOVE BRAKE TUBE

a.

Disconnect the master cylinder to tube connector tube from the clutch master cylinder assembly (Click hereDrivetrain>CLUTCH>CLUTCH MASTER CYLINDER>REMOVAL).


b.
C368784

Disconnect the 2 brake tubes and master cylinder to tube connector tube from the clamp.


c.

Remove the bolt and clamp from the brake pedal support sub-assembly.


d.
C368783

Using a union nut wrench, disconnect the 2 brake tubes and master cylinder to tube connector tube from the tube connector sub-assembly.


e.

Remove the 2 brake tubes and master cylinder to tube connector tube.


Hide 11.DISCONNECT VACUUM HOSE ASSEMBLY

C368782

a.

Slide the clip and disconnect the vacuum hose assembly.


Hide 55106D 12.REMOVE PEDAL BRACKET SUB-ASSEMBLY

a.

Disconnect the clamp from the pedal bracket sub-assembly.


b.
C373981

Remove the 5 bolts, 2 nuts and pedal bracket sub-assembly.


Hide 44610 13.REMOVE BRAKE BOOSTER ASSEMBLY

a.
C373994

Remove the clip and push rod pin.


b.

Remove the 4 nuts and brake booster assembly.


Hide 47264D 14.REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS

a.

Loosen the lock nut, remove the master cylinder push rod clevis and lock nut.