The engine control information from the ECM to the skid control ECU (brake actuator assembly) via CAN communication.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1203 | Either of the following is detected:
1.
Engine model information sent from the ECM does not match the information stored in the skid control ECU. 2.
No system information stored in the skid control ECU. 3.
Incorrect installation of the skid control ECU or ECM. |
·
ECM malfunction or ECM with incorrect part number installed ·
Skid control ECU (Brake actuator assembly) |
When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information (Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM(w/ Brake pedal Load Sensing Switch)>CALIBRATION).
Check that the proper ECM is installed.
| Result | Proceed to |
|---|---|
| Proper ECM is installed | A |
| Proper ECM are not installed | B |
| Engine Type | See page |
|---|---|
| N04C-UH | ( )
|
| N04C-VQ | ( )
|
| N04C-VL | ( )
|
| 2TR-FE | ( )
|
A
B
Check if the brake actuator assembly had been replaced before the DTC was recorded.
| Result | Proceed to |
|---|---|
| The brake actuator assembly is not replaced | A |
| The brake actuator assembly is replaced | B |
A
B
Turn the ignition switch off.
Check if the same DTC is recorded (Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM(w/ Brake pedal Load Sensing Switch)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC C1203 is not output | A |
| DTC C1203 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Perform initialization and calibration (Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM(w/ Brake pedal Load Sensing Switch)>CALIBRATION).
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch off.
Check if the same DTC is recorded (Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM(w/ Brake pedal Load Sensing Switch)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC C1203 is not output | A |
| DTC C1203 is output | B |
A
B