23250
1.INSTALL FUEL INJECTOR ASSEMBLY
Apply a light coat of grease or gasoline to new O-rings and install them onto the injector vibration insulator.
Make sure that the O-rings are installed between the parts correctly.
Install the new injector vibration insulators onto the fuel injector assembly.
Apply a light coat of grease or gasoline to the contact portion of the delivery pipe touches the O-ring.
To install the fuel injector into the fuel delivery pipe, push the fuel injector while twisting it right and left.
Be careful not to twist the O-ring.
After installing the fuel injector, check that it turns smoothly. If not, reinstall it with a new O-ring.
23807
2.INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY
Install a new O-ring onto the spacer.
Install the 4 spacers onto the cylinder head.
Install the 2 spacers.
Temporarily install the 2 bolts and fuel delivery pipe together with the 4 injectors.v
Do not drop the fuel injector when installing the fuel delivery pipe.
Make sure that the fuel injector turns smoothly.
Fully tighten the 2 bolts.
12 N*m (122 kgf*cm, 9 ft.*lbf)
Install the 2 bolts and fuel pressure pulsation damper assembly.
9.0 N*m (92 kgf*cm, 80 in.*lbf)
Install the wire harness clamp.
Connect the 4 injector connectors.
Install the fuel hose with the clip.
23271F
3.CONNECT FUEL HOSE
Align the connector and pipe. Push on the connector until the retainer locks with a click sound.
Pull the connector to check that the connector is securely connected.
Install the connector and lock it with the fuel hose connector cover.
22030
4.INSTALL THROTTLE WITH MOTOR BODY ASSEMBLY
17861
5.INSTALL INTAKE AIR CONNECTOR
6.ADD ENGINE COOLANT
7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5.4 N*m (55 kgf*cm, 48 in.*lbf)
8.INSPECT FOR FUEL LEAK
9.INSPECT FOR ENGINE COOLANT LEAK
58701A
10.INSTALL FRONT ENGINE SERVICE COVER PANEL SUB-ASSEMBLY
33506F
11.INSTALL FLOOR SHIFT CONTROL SHIFT LEVER RETAINER SUB-ASSEMBLY
58123A
12.INSTALL SHIFT AND SELECT LEVER SUPPORT WITH BOOTS
58420
13.INSTALL NO. 2 ENGINE SERVICE HOLE COVER ASSEMBLY
58521D
14.INSTALL ENGINE SERVICE HOLE COVER MAT
58734B
15.INSTALL REAR ENGINE SERVICE COVER WEATHERSTRIP
58410
16.INSTALL ENGINE SERVICE HOLE MAIN COVER