88645H
1.INSTALL NO. 1 PRESSURE SWITCH
Remove the vinyl tape from the cooler refrigerant liquid pipe A and accessory assembly.
Sufficiently apply compressor oil to the fitting surface of the cooler refrigerant liquid pipe A and No. 1 pressure switch.
ND-OIL 8 or equivalent
Do not use any compressor oil other than ND-OIL 8 or equivalent. If any compressor oil other than ND-OIL 8 or equivalent is used, compressor motor insulation performance may decrease, resulting in leakage of electric power.
| *a | Turn |
| *b | Hold |
Using a 27 mm deep socket wrench, install the No. 1 pressure switch as shown in the illustration.
Do not apply excessive force to the cooler refrigerant liquid pipe A.
Make sure not to cut the O-ring while installing it. (Cut O-rings cannot be installed)
Connect the connector.
88471
2.INSTALL RECEIVER AIR CONDITIONING TANK
88716B
3.INSTALL COOLER REFRIGERANT LIQUID PIPE B
59401
4.INSTALL COOLER CONDENSER COVER SUB-ASSEMBLY
5. CHARGE REFRIGERANT
6. WARM UP ENGINE
7.INSPECT FOR REFRIGERANT LEAK