17111
1.INSTALL INTAKE MANIFOLD
| *a | Seal Packing |
Apply seal packing to the areas shown in the illustration.
Toyota Genuine Seal Packing Black, Three Bond 1207B or equivalent
2.2 mm (0.0866 in.)
Remove any oil from the contact surface.
Install the intake manifold within 3 minutes after applying seal packing.
Do not start the engine for at least 2 hours after installation.
|
Bolt |
|
Nut |
Install the intake manifold with the 8 bolts and 2 nuts.
Install the wiring harness bracket sub-assembly with the 2 bolts.
Attach the wire harness clamp and install the 2 bolts.
17113
2.INSTALL INTAKE PIPE
| *a | Seal Packing |
Apply seal packing to the areas shown in the illustration.
Toyota Genuine Seal Packing Black, Three Bond 1207B or equivalent
2.2 mm (0.0866 in.)
Remove any oil from the contact surface.
Install the intake manifold within 3 minutes after applying seal packing.
Do not start the engine for at least 2 hours after installation.
|
Bolt |
|
Nut |
Install the intake pipe with the 3 bolts and 2 nuts.
23810A
3.INSTALL COMMON RAIL ASSEMBLY
25620
4.INSTALL EGR VALVE ASSEMBLY
89424G
5.INSTALL INTAKE AIR TEMPERATURE SENSOR
6.INSTALL MANIFOLD ABSOLUTE PRESSURE SENSOR
26100
7.INSTALL DIESEL THROTTLE BODY ASSEMBLY