The ECM sends the engine speed signal to the transmission control ECU assembly. When there is a malfunction in the engine speed signal, the transmission control ECU assembly stores a DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Memory |
|---|---|---|---|---|---|
| P0725 | Engine Speed Input Circuit | 1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other
1.
Vehicle is being driven (Shift lever not in P or N position) 2.
Engine speed (NE): Below 300 rpm 3.
4 seconds or more 4.
2 trip detection logic |
·
Wire harness or connector (NE signal circuit) ·
ECM ·
Transmission control ECU assembly |
O/D OFF Indicator Light: Blinking | DTC stored |
After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
Perform the D Position Shift Test inspection in Road Test.*1
Click hereDrivetrain>A861E (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM>ROAD TEST
Turn the ignition switch off.
Perform step (*1) again.
Check for DTCs again.
Perform initialization when parts related to the automatic transmission are replaced.
Click hereDrivetrain>A861E (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM>INITIALIZATION
Check whether crank angle sensor system DTCs have been output.
for N04C-WA: Click hereEngine / Hybrid System>N04C-WA (ENGINE CONTROL)>ECD SYSTEM>DTC CHECK / CLEAR
for N04C-VJ: Click hereEngine / Hybrid System>N04C-VJ (ENGINE CONTROL)>ECD SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| Crank angle sensor system DTCs have been output | A |
| Crank angle sensor system DTC have not been output | B |
If crank angle sensor system DTCs have been output, troubleshoot the ECD system first.
A
B
for N04C-WA: Click hereEngine / Hybrid System>N04C-WA (ENGINE CONTROL)>ECD SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
for N04C-VJ: Click hereEngine / Hybrid System>N04C-VJ (ENGINE CONTROL)>ECD SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
| *a | Component with harness connected
(Transmission Control ECU Assembly) |
Connect an oscilloscope between the transmission control ECU assembly terminals specified in the table below.
| Item | Content |
|---|---|
| Terminal | NE - E |
| Tool setting | 2 V/DIV, 20 ms/DIV |
| Vehicle conditions | Engine idling |
The wavelength shortens as the engine speed increases.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the ECM connector.
Disconnect the transmission control ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A115-15 (TAC) - B134-15 (NE) | Always | Below 1 Ω |
| A115-15 (TAC) or B134-15 (NE) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG