Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › MASS AIR FLOW METER
RM24M0E _51 Engine / Hybrid System _059540 2GR-FE ENGINE CONTROL _0291771 MASS AIR FLOW METER A

2GR-FE ENGINE CONTROL  MASS AIR FLOW METER  INSTALLATION  


PROCEDURE

Hide 22204 1.INSTALL MASS AIR FLOW METER

a.
U188432

Install the mass air flow meter with the 2 screws.

NOTICE:

Make sure that the O-ring is not cracked or jammed when installing.



b.

Connect the mass air flow meter connector.


Hide 2.INSTALL COWL TOP OUTER PANEL WITH WINDSHIELD WIPER MOTOR AND LINK

a.

Install the cowl top outer panel with windshield wiper motor and link (See page Vehicle Interior>WIPER / WASHER>FRONT WIPER MOTOR>INSTALLATION).


Hide 55781F 3.INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

Hide 55742A 4.INSTALL HOOD TO COWL TOP SEAL

Hide 85291B 5.INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH

a.

Install the front wiper arm and blade assembly (See page Vehicle Interior>WIPER / WASHER>FRONT WIPER RUBBER>INSTALLATION).


Hide 85291A 6.INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH

Hide 7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 8.PERFORM INITIALIZATION

a.

Perform initialization (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting the cable from the negative (-) battery terminal.