Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › THROTTLE BODY › from 2016.05
RM24M0E _51 Engine / Hybrid System _059540 2GR-FE ENGINE CONTROL _0291775 THROTTLE BODY A

2GR-FE ENGINE CONTROL  THROTTLE BODY  INSTALLATION  


PROCEDURE

Hide 22210 1.INSTALL THROTTLE BODY

a.
A133820

Install a new gasket onto the intake surge tank.


b.
A135709

Install the throttle body and 4 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.
A135707

Connect the wire harness clamp.


d.

Connect the throttle position sensor and control motor connector.


e.
A135708

Connect the water by-pass hoses to the throttle body.


Hide 17705 2.INSTALL AIR CLEANER CAP

a.
A395915E02
0.542,0.25 0.75,0.427 0.208,0.177 10 true [A] 0.979,1.031 1.188,1.24 0.208,0.208 10 true [B] 2.365,0.719 2.563,0.917 0.198,0.198 10 true [C]

Install the air cleaner cap and tighten the hose band [A].


b.

Connect the ventilation hose [B].


c.

Connect the mass air flow meter connector [C].


Hide 3.INSTALL COWL TOP OUTER PANEL WITH WINDSHIELD WIPER MOTOR AND LINK

a.

Install the cowl top outer panel with windshield wiper motor and link (See page Vehicle Interior>WIPER / WASHER>FRONT WIPER MOTOR>INSTALLATION).


Hide 47202 4.INSTALL BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY

Hide 55781F 5.INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

Hide 53867H 6.INSTALL FRONT FENDER TO COWL SIDE SEAL LH

Hide 53866J 7.INSTALL FRONT FENDER TO COWL SIDE SEAL RH

Hide 85291B 8.INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH

Hide 85291A 9.INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH

Hide 16470 11.INSTALL RADIATOR RESERVOIR TANK SUB-ASSEMBLY

Hide 51442 13.INSTALL NO. 2 ENGINE UNDER COVER

Hide 14.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 17.PERFORM INITIALIZATION

a.

Perform initialization (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting the cable from the negative (-) battery terminal.