Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › ECM › from 2016.05
RM24M0E _51 Engine / Hybrid System _059540 2GR-FE ENGINE CONTROL _0291780 ECM A

2GR-FE ENGINE CONTROL  ECM  INSTALLATION  


PROCEDURE

Hide 89661 1.INSTALL ECM

a.
A132385

Install the 2 brackets to the ECM with the 4 screws.

Torque:
3.0 N*m (30 kgf*cm, 27 in.*lbf)


b.
A124572

Connect the 2 ECM connectors.

NOTICE:

When connecting the connector, make sure that dirt, water and other foreign matter do not become stuck between the connector and the other part.


i.

Connect the 2 ECM connectors and lower the 2 levers.

NOTICE:

Make sure that the 2 levers are securely lowered.




c.
A132384

Install the ECM with the 3 bolts.

Torque:
12.5 N*m (127 kgf*cm, 9 ft.*lbf)


d.

Connect the wire harness clamp.


Hide 17752 2.INSTALL NO. 2 AIR CLEANER INLET

a.
U188326

Insert the No. 2 air cleaner inlet to the No. 1 air cleaner inlet and then install the bolt.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 28800 4.INSTALL BATTERY

a.
A132382

Install the battery and battery tray.


b.

Install the battery hold down clamp with the bolt and nut.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


c.

Connect the 2 wire harness clamps.


Hide 5.INSTALL AIR CLEANER CASE

a.
A132379

Install the air cleaner case with the 3 bolts.

Torque:
7.0 N*m (71 kgf*cm, 62 in.*lbf)


b.

Connect the harness clamp.


Hide 6.INSTALL COWL TOP OUTER PANEL WITH WINDSHIELD WIPER MOTOR AND LINK

a.

Install the cowl top outer panel with windshield wiper motor and link (See page Vehicle Interior>WIPER / WASHER>FRONT WIPER MOTOR>INSTALLATION).


Hide 47202 7.INSTALL BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY

Hide 55781F 8.INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

Hide 53867H 9.INSTALL FRONT FENDER TO COWL SIDE SEAL LH

Hide 53866J 10.INSTALL FRONT FENDER TO COWL SIDE SEAL RH

Hide 85291B 11.INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH

Hide 85291A 12.INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH

Hide 14.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 15.PERFORM REGISTRATION

a.

When replacing the ECM, perform vehicle stability control system recognition in ECM (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>REGISTRATION).


Hide 16.RESET MEMORY (for Automatic Transaxle)

a.

When replacing the ECM, perform the RESET MEMORY procedure (A/T initialization) (See page Drivetrain>U660E (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSAXLE SYSTEM>INITIALIZATION).


Hide 17.PERFORM INITIALIZATION

a.

Perform initialization (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting the cable from the negative (-) battery terminal.