1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
16470
2.REMOVE RADIATOR RESERVOIR TANK SUB-ASSEMBLY
3.REMOVE FRONT WIPER ARM HEAD CAP
85291A
4.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH
85291B
5.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH
53866J
6.REMOVE FRONT FENDER TO COWL SIDE SEAL RH
53867H
7.REMOVE FRONT FENDER TO COWL SIDE SEAL LH
55781F
8.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
47202
9.REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
10.REMOVE COWL TOP OUTER PANEL WITH WINDSHIELD WIPER MOTOR AND LINK
Remove the cowl top outer panel with windshield wiper motor and link (See page Vehicle Interior>WIPER / WASHER>FRONT WIPER MOTOR>REMOVAL).
17190
11.REMOVE INTAKE AIR SURGE TANK ASSEMBLY
11101J
12.REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 1 Exhaust Side)
Disconnect the camshaft timing oil control valve assembly connector.
Remove the bolt and camshaft timing oil control valve assembly.
Remove the O-ring from the camshaft timing oil control valve.
11101J
13.REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 1 Intake Side)
Disconnect the camshaft timing oil control valve assembly connector.
Remove the bolt and camshaft timing oil control valve assembly.
Remove the O-ring from the camshaft timing oil control valve.
11101J
14.REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 2 Exhaust Side)
Disconnect the camshaft timing oil control valve assembly connector.
Remove the bolt and camshaft timing oil control valve assembly.
Remove the O-ring from the camshaft timing oil control valve.
11101J
15.REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 2 Intake Side)
Disconnect the camshaft timing oil control valve assembly connector.
Remove the bolt and camshaft timing oil control valve assembly.
Remove the O-ring from the camshaft timing oil control valve.