Home › Engine / Hybrid System › 2AZ-FE ENGINE CONTROL › CAMSHAFT POSITION SENSOR
RM24M0E _51 Engine / Hybrid System _059541 2AZ-FE ENGINE CONTROL _0291784 CAMSHAFT POSITION SENSOR A

2AZ-FE ENGINE CONTROL  CAMSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11102A 1.INSTALL CAMSHAFT POSITION SENSOR

NOTICE:

Make sure that the O-ring is not cracked or jammed when installing.


A095434E31
1.563,1.375 1.26,1.604 false 0.667,1.563 1.125,1.781 0.458,0.219 10 false O-Ring

a.

Apply a light coat of engine oil to the O-ring of the sensor.


b.
A132370

Install the sensor with the bolt.

Torque:
9.0 N*m (90 kgf*cm, 80 in.*lbf)


c.

Connect the sensor connector.


Hide 85110 3.INSTALL COWL TOP OUTER PANEL WITH WINDSHIELD WIPER MOTOR AND LINK

a.

Install the cowl top outer panel with windshield wiper motor and link (see page Vehicle Interior>WIPER / WASHER>FRONT WIPER MOTOR>INSTALLATION).


Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 5.CHECK FOR ENGINE OIL LEAKAGE

Hide 6. INITIALIZATION

a.

Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting the cable from the negative (-) battery terminal.