Home › Engine / Hybrid System › 2AZ-FE ENGINE CONTROL › THROTTLE BODY
RM24M0E _51 Engine / Hybrid System _059541 2AZ-FE ENGINE CONTROL _0291793 THROTTLE BODY A

2AZ-FE ENGINE CONTROL  THROTTLE BODY  INSTALLATION  


PROCEDURE

Hide 22210 1.INSTALL THROTTLE BODY

a.
A124566

Install a new gasket onto the intake manifold.


b.
A229371

Install the throttle body and fuel pipe support with the 4 bolts.

Torque:
30 N*m (305 kgf*cm, 22 ft.*lbf)


c.
A229370

Connect the fuel tube to the clamp.


d.

Connect the wire harness clamp.


e.

Connect the throttle position sensor and control motor connector.


f.

Connect the No. 2 water by-pass hose to the throttle body.


g.

Connect the No. 1 water by-pass hose to the throttle body.


h.

Connect the purge line hose to the throttle body.


Hide 17705 2.INSTALL AIR CLEANER CAP

a.

Install the air cleaner filter element onto the air cleaner case.


b.
A229391E01
0.897,0.227 1.085,0.415 0.189,0.188 10 *1 2.362,0.249 2.551,0.436 0.189,0.188 10 *3 2.062,0.469 2.250,0.657 0.189,0.188 10 *2 2.485,0.428 2.534,0.701 false 2.265,0.564 2.471,0.717 false

Connect the No. 1 air cleaner hose to the throttle body and unlock the No. 1 air cleaner hose clamp.

Text in Illustration
*1 No. 1 Air Cleaner Hose Clamp
*2 Groove
*3 Tab

NOTICE:
·

Align the groove of the air cleaner hose with the tab of the throttle body and install the hose.




c.
A132377E04
0.958,4.219 1.875,3.667 false 0.771,4.156 0.938,4.385 0.167,0.229 10 false *1

Insert the hinge part of the air cleaner cap into the air cleaner case, then engage the 2 hook clamps.

Text in Illustration
*1 Hinge


d.
A132371

Connect the purge line hose, clamp and purge VSV.


e.
A132373

Connect the No. 2 ventilation hose to the cylinder head cover.


f.
A132372

Connect the mass air flow meter connector and clamp.


Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 85110 5.INSTALL COWL TOP OUTER PANEL WITH WINDSHIELD WIPER MOTOR AND LINK

a.

Install the cowl top outer panel with windshield wiper motor and link (See page Vehicle Interior>WIPER / WASHER>FRONT WIPER MOTOR>INSTALLATION).


Hide 7.INSPECT THROTTLE BODY

Hide 8.PERFORM INITIALIZATION

a.

Perform initialization (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting the cable from the negative (-) battery terminal.