Refer to DTC P0115 (see page Engine / Hybrid System>2AZ-FE ENGINE CONTROL>SFI SYSTEM>P0115).
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0116 | Engine Coolant Temperature (ECT) between -40°C and 60°C (-40°F and 140°F) when engine started, and conditions (a) and (b) met (2 trip detection logic):
(a) Vehicle driven at varying speeds (accelerated and decelerated) (b) ECT remains within 3°C (5.4°F) of initial ECT |
·
Thermostat ·
Engine Coolant Temperature (ECT) sensor |
If any of DTCs P0115, P0117 or P0118 are output simultaneously with DTC P0116, the engine coolant temperature sensor may have an open or a short circuit. Troubleshoot those DTCs first.
Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.
When the DTC is output, check the engine coolant temperature using the intelligent tester. Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Coolant Temp. If the Coolant Temp value is lower than the actual engine coolant temperature, the engine coolant temperature sensor circuit may be malfunctioning. In this case, check the wire harnesses and connectors (and those connections) between the ECM and the engine coolant temperature sensor first.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTC P0116 is output | A |
| DTC P0116 and other DTCs are output | B |
If any DTCs other than P0116 are output, troubleshoot those DTCs first.
A
B
Inspect the thermostat (thermostat opening temperature) (See page Engine / Hybrid System>2AZ-FE COOLING>THERMOSTAT>INSPECTION).
OK
NG