89661
1.INSTALL ECM
Install the 2 brackets to the ECM with the 4 screws.
Connect the 2 ECM connectors.
When connecting the connector, make sure that dirt, water and other foreign matter do not become stuck between the connector and the other part.
Connect the 2 ECM connectors and lower the 2 levers.
Make sure that the 2 levers are securely lowered.
Install the ECM with the 3 bolts.
Connect the wire harness clamp.
17752
2.INSTALL NO. 2 AIR CLEANER INLET
Insert the No. 2 air cleaner inlet to the No. 1 resonator, and then install the bolt.
28800
3.INSTALL BATTERY
Install the battery support, battery and battery insulator.
Install the battery hold down clamp with the bolt and nut.
Connect the 2 wire harness clamps.
17700
4.INSTALL AIR CLEANER CASE
Install the air cleaner case with the 3 bolts.
Connect the harness clamp.
17705
5.INSTALL AIR CLEANER CAP
85110
6.INSTALL COWL TOP OUTER PANEL WITH WINDSHIELD WIPER MOTOR AND LINK
Install the cowl top outer panel with windshield wiper motor and link (See page Vehicle Interior>WIPER / WASHER>FRONT WIPER MOTOR>INSTALLATION).
28800A
7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
8.PERFORM REGISTRATION
When replacing the ECM, perform vehicle stability control system recognition in ECM (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>REGISTRATION).
9.RESET MEMORY
When replacing the ECM, perform the RESET MEMORY procedure (See page Drivetrain>U241E (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSAXLE SYSTEM>INITIALIZATION)(for U241E).
When replacing the ECM, perform the RESET MEMORY procedure (See page Drivetrain>K112 (CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>INITIALIZATION)(for K112).
10.PERFORM INITIALIZATION
Perform initialization (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Certain systems need to be initialized after disconnecting the cable from the negative (-) battery terminal.