Do not operate the brake actuator while air is in the brake system or in the brake master cylinder. Doing so may cause air to enter the brake actuator.
If bleeding the brake actuator is difficult due to air in the actuator, replace it with a new one.
Wash off brake fluid immediately if it comes in contact with any painted surface.
If bleeding is performed with the engine running or the engine switch on (IG), DTC C1441 will be stored. Make sure to clear the DTCs when work is complete.
If any work is performed on the brake system or if air in the brake lines is suspected, bleed air from the brake system.
1.FILL RESERVOIR WITH BRAKE FLUID
Fill reservoir with brake fluid.
SAE J1703 or FMVSS No. 116 DOT3
Before replacing the brake fluid or bleeding the brake system, confirm that the reservoir located above the master cylinder assembly is filled with brake fluid.
2.BLEED AIR FROM BRAKE MASTER CYLINDER
If the master cylinder has been disassembled or if the reservoir becomes empty, bleed air from the master cylinder.
for LHD:
Remove the air cleaner case (for 2AZ-FE: see page Engine / Hybrid System>2AZ-FE ENGINE CONTROL>ECM>REMOVAL, for 2GR-FE: Engine / Hybrid System>2GR-FE ENGINE CONTROL>ECM>REMOVAL).
Using a union nut wrench, disconnect the 2 brake lines from the master cylinder.
Slowly depress and hold down the brake pedal.
Block the outer holes with your fingers, and release the pedal.
Repeat the 2 previous steps 3 or 4 times.
Using a union nut wrench, connect the 2 brake lines to the master cylinder.
| *a | Torque Wrench Fulcrum Length |
Do not kink or damage the brake lines.
Do not allow any foreign matter such as dirt or dust to enter the brake lines from the connecting parts.
Calculate the torque wrench reading when changing the fulcrum length for the torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When using a union nut wrench (fulcrum length of 20 mm (0.787 in.)) + torque wrench (fulcrum length of 250 mm (9.84 in.)):
18 N*m (184 kgf*cm, 13 ft.*lbf)
for LHD:
Install the air cleaner case (for 2AZ-FE: see page Engine / Hybrid System>2AZ-FE ENGINE CONTROL>ECM>INSTALLATION, for 2GR-FE: Engine / Hybrid System>2GR-FE ENGINE CONTROL>ECM>INSTALLATION).
3.BLEED AIR FROM BRAKE LINE
To prevent air from entering the brake lines, bleed the brake lines while keeping the reservoir filled to the MAX line with brake fluid.
Remove the bleeder plug cap.
Connect a vinyl tube to the bleeder plugs.
Depress the brake pedal several times, and then loosen the bleeder plug with the pedal depressed.
When fluid stops coming out, immediately tighten the bleeder plug. Then release the pedal.
Repeat the 2 previous steps until all the air in the brake fluid is gone.
Tighten the bleeder plug.
for front brake
for rear brake
Install the cap.
Bleed air from the brake line for each wheel by repeating the above procedures.
4.CHECK BRAKE FLUID LEVEL IN RESERVOIR
5.INSPECT FOR BRAKE FLUID LEAK
6. CHECK AND CLEAR DTC