Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
28800
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2.REMOVE FRONT BUMPER ASSEMBLY
for Standard: (See page Vehicle Interior>EXTERIOR>FRONT BUMPER(for Standard)>REMOVAL)
for Sport Package: (See page Vehicle Interior>EXTERIOR>FRONT BUMPER(for Sport Package)>REMOVAL)
52544
3.REMOVE FRONT BUMPER SIDE SEAL LH (for LED Headlight)
4.REMOVE HEADLIGHT ASSEMBLY
except LED Headlight: (See page Vehicle Interior>LIGHTING>HEADLIGHT ASSEMBLY(except LED Headlight)>REMOVAL)
for LED Headlight: (See page Vehicle Interior>LIGHTING>HEADLIGHT ASSEMBLY(for LED Headlight)>REMOVAL)
89174A
5.REMOVE FRONT AIRBAG SENSOR LH
Disconnect the sensor connector.
Remove the bolt and sensor.