Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SIDE AIRBAG SENSOR(for Front Side) › 2013.04–2016.05
RM24M0E _58 Vehicle Interior _059562 SUPPLEMENTAL RESTRAINT SYSTEMS _0291906 SIDE AIRBAG SENSOR(for Front Side) A

SUPPLEMENTAL RESTRAINT SYSTEMS  SIDE AIRBAG SENSOR(for Front Side)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RH side and LH side.

·

The procedures listed below are for the LH side.



CAUTION:

Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

Hide 89860A 1.INSTALL SIDE AIRBAG SENSOR LH

a.
C137825

Install the sensor with the nut.

Torque:
9.0 N*m (92 kgf*cm, 82 in.*lbf)

NOTICE:
·

If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

·

When installing the airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.




b.

Check that there is no looseness in the installation parts of the sensor.


c.

Connect the connector.


Hide 73220 2.INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH

a.

Install the front seat outer belt (see page Vehicle Interior>SEAT BELT>FRONT SEAT OUTER BELT ASSEMBLY>INSTALLATION).


Hide 28800 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 4.PERFORM INITIALIZATION

a.

Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.



Hide 5.CHECK SRS WARNING LIGHT