Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CENTER AIRBAG SENSOR ASSEMBLY › 2013.04–2016.05
RM24M0E _58 Vehicle Interior _059562 SUPPLEMENTAL RESTRAINT SYSTEMS _0291909 CENTER AIRBAG SENSOR ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  CENTER AIRBAG SENSOR ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

Hide 89170 1.INSTALL CENTER AIRBAG SENSOR ASSEMBLY

C366255

a.

Install the sensor with the 3 bolts.

Torque:
17.5 N*m (179 kgf*cm, 13 ft.*lbf)

NOTICE:
·

If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

·

When installing the airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.




b.

Connect the sensor connectors.


Hide 58534E 2.INSTALL FLOOR CARPET COVER CENTER LH

Hide 58533C 3.INSTALL FLOOR CARPET COVER CENTER RH

Hide 28800 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 5.PERFORM INITIALIZATION

a.

Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.



Hide 6.CHECK SRS WARNING LIGHT