45130
1.INSTALL STEERING PAD ASSEMBLY
Check that the engine switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Connect the airbag connector to the steering pad assembly.
| *a | Airbag Connector |
| *b | Horn Connector |
| *c | Airbag Connector Lock |
When connecting any airbag connector, take care not to damage the airbag wire harness.
Push in the airbag connector lock to install the airbag connector.
Connect the horn connector to the steering pad assembly.
Push the steering pad assembly to engage the 3 pins carefully to install the steering pad assembly.
Make sure that the pins are securely inserted into the steering wheel assembly holes.
Make sure to engage the 2 upper pins first.
Make sure that the steering pad assembly is securely installed.
45187
2.INSTALL LOWER NO. 3 STEERING WHEEL COVER
Engage the claw and guide to install the lower No. 3 steering wheel cover.
45186
3.INSTALL LOWER NO. 2 STEERING WHEEL COVER
Engage the claw and guide to install the lower No. 2 steering wheel cover.
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
45130
5.INSPECT STEERING PAD ASSEMBLY
Make sure that the horn sounds.
If the horn does not sound, inspect the horn system (See page Vehicle Interior>HORN>HORN SYSTEM>PROBLEM SYMPTOMS TABLE).
6. PERFORM DIAGNOSTIC SYSTEM CHECK
7.INSPECT SRS WARNING LIGHT