Use the same procedures for the RH and LH side.
The procedures listed below are for the LH side.
81270
1.INSTALL LICENSE PLATE LIGHT ASSEMBLY
Disconnect the connector.
Attach the 2 claws to install the license plate light.
76802C
2.INSTALL BACK DOOR OUTSIDE GARNISH
67750
3.INSTALL BACK DOOR TRIM BOARD ASSEMBLY
62581H
4.INSTALL REAR WINDOW SIDE GARNISH RH
62582H
5.INSTALL REAR WINDOW SIDE GARNISH LH
67848
6.INSTALL BACK DOOR SERVICE HOLE COVER LH
67939D
7.INSTALL BACK DOOR GARNISH CENTER
8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
9.PERFORM INITIALIZATION
Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.