Home › Vehicle Interior › ENGINE HOOD / DOOR › FRONT DOOR › from 2016.05
RM24M0E _58 Vehicle Interior _059569 ENGINE HOOD / DOOR _0292026 FRONT DOOR A

ENGINE HOOD / DOOR  FRONT DOOR  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the LH side and RH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 28800 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 67492A 2.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

a.
B136618

Using a screwdriver, detach the clip and claw, and remove the garnish.

HINT:

Tape the screwdriver tip before use.



Hide 69278B 3.REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH

a.
B136619

Using a screwdriver, detach the 3 claws and remove the bezel plug.

HINT:

Tape the screwdriver tip before use.



Hide 74232 4.REMOVE FRONT ARMREST BASE PANEL UPPER LH

a.
B148620E01
0.44,3.188 0.777,3.333 0.336,0.145 10 Claw

Using a screwdriver, detach the 10 claws.

HINT:

Tape the screwdriver tip before use.



b.

Disconnect the connector and remove the panel.


Hide 84040 5.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY (for Driver Side)

a.
B148621

Remove the 3 screws and switch from the panel.


Hide 84810 6.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY (for Passenger Side)

a.
B148622E01
0.427,1.911 0.787,2.071 0.360,0.161 10 Claw

Using a screwdriver, detach the 2 claws and remove the switch from the panel.


Hide 67602 7.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

a.
B136620

Using a screwdriver, detach the claw and remove the cover.


b.
U188640E01
0.575,2.997 1.653,3.174 1.078,0.178 10 Protective Tape

Remove the 2 cushion rubbers.


c.

Remove the 2 screws.


d.

Using a screwdriver, detach the 9 clips.

HINT:

Tape the screwdriver tip before use.



e.

Remove the trim board upward.

HINT:

In order to prevent the door panel from being damaged, cover the areas indicated by the arrows in the illustration with protective tape.



f.
U188547

Disconnect the 2 cables from the inside handle, as shown in the illustration.


g.
B148623E01
0.407,3.127 0.809,3.276 0.402,0.149 10 Claws

Using a screwdriver, detach the 7 claws and remove the weatherstrip inner.

HINT:

Tape the screwdriver tip before use.



h.

Remove the 3 screws and inside handle.


Hide 67832 8.REMOVE FRONT DOOR SERVICE HOLE COVER LH

a.
B136622

Remove the 2 screws and No. 1 reinforcement.


b.

Disconnect the connector and clamps.


c.

Remove the service hole cover.

NOTICE:

Remove the remaining tape on the door side.



Hide 87940 9.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH

a.
B136623

Disconnect the connector.


b.

Remove the 3 nuts and mirror.

NOTICE:

Be careful when removing the nuts as the mirror may fall and become damaged.



Hide 86160 10.REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

Hide 68210C 11.REMOVE FRONT DOOR GLASS WEATHERSTRIP ASSEMBLY OUTER LH

Hide 68102 12.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

a.
B136624

Open the door glass until the bolts appear in the service holes.


b.

Remove the 2 bolts holding the door glass to the window regulator.


c.
B136625

Remove the door glass in the direction indicated by the arrows in the illustration.

NOTICE:
·

Do not damage the door glass.

·

Be careful when removing the bolts as the door glass may fall and become damaged.




d.

Remove the glass run.


Hide 69802 13.REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

a.
B136626

Disconnect the window regulator motor connector.


b.

Remove the 6 bolts and window regulator.

NOTICE:

Be careful when removing the bolts as the window regulator may fall and become damaged.


HINT:

Remove the window regulator through the service hole.



Hide 85720C 14.REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

a.

Using a T25 "TORX" driver, remove the 3 screws and window regulator motor.


Hide 67404F 15.REMOVE FRONT DOOR FRAME SUB-ASSEMBLY REAR LOWER LH

a.
B136627

Remove the bolt and frame.


Hide 69217D 16.REMOVE FRONT DOOR OUTSIDE HANDLE COVER

a.
B136628

Remove the hole plug.


b.

Using a T30 "TORX" socket, loosen the screw and remove the outside handle cover with the door lock key cylinder installed.


Hide 69040A 17.REMOVE FRONT DOOR WITH MOTOR LOCK ASSEMBLY LH

a.
B136629

Disconnect the door lock connector.


b.

Using a T30 "TORX" socket, remove the 3 screws and lock.

HINT:

Remove the door lock through the service hole.



Hide 69220 18.REMOVE FRONT DOOR HANDLE ASSEMBLY OUTSIDE LH

a.

w/ Entry Function:

Disconnect the connector.


b.
B136630

Push and pull the outside handle in the direction indicated by the arrow in the illustration, and remove the outside handle.


c.

Remove the outside handle pads front and rear.


Hide 69202A 19.REMOVE FRONT DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY LH

a.

w/ Entry Function:

Disconnect the connector.


b.
B136631E01
0.059,0.009 0.735,0.182 0.675,0.173 10 Outside: 0.059,1.881 0.735,2.054 0.675,0.173 10 Inside: 2.619,0.235 3.081,0.432 0.462,0.197 10 Frame 1.833,1.774 2.128,1.970 0.295,0.197 10 Nut 1.28,1.508 1.686,1.705 0.406,0.197 10 Cover 1.143,0.354 1.899,0.521 0.756,0.167 10 Door Panel 2.153,1.089 1.964,1.456 1.964,1.456 1.964,1.735 false 1.89,1.032 1.52,1.305 1.52,1.305 1.52,1.513 false 2.4,0.748 2.491,0.31 false 2.491,0.31 2.565,0.31 false 2.017,0.443 2.343,0.443 false 2.343,0.443 2.216,0.635 false 2.639,3.391 3.015,3.539 0.376,0.148 10 Slide 2.31,4.099 3.023,4.248 0.714,0.148 10 Open Rod 0.224,0.386 0.600,0.534 0.376,0.148 10 Slide 1.437,3.883 2.114,4.184 2.114,4.184 2.26,4.184 false

Using a T30 "TORX" socket, loosen the screw.


c.

Slide the outside handle frame in the direction indicated by the arrow in the illustration, and remove it.

HINT:

Remove the outside handle frame through the service hole.



d.

Remove the open rod from the outside handle frame.


Hide 68620 20.REMOVE FRONT DOOR CHECK ASSEMBLY LH

a.
B136632

Remove the 3 bolts and door check.


Hide 67862 21.REMOVE FRONT DOOR WEATHERSTRIP LH

a.

Using a clip remover, detach the clips and remove the weatherstrip.

HINT:

If the clips are damaged, replace them with new ones.



Hide 82152 22.REMOVE FRONT DOOR WIRE LH

a.
B136633

Disconnect the wire clips.


b.

Remove the 2 bolts and wire.


Hide 67663D 23.REMOVE DOOR FRAME GARNISH LH

B144424

a.

Using a screwdriver, detach the claw and remove the garnish.

HINT:

Tape the screwdriver tip before use.



Hide 24.REMOVE FRONT DOOR MUDGUARD SUB-ASSEMBLY (for Standard)

Hide 25.REMOVE FRONT DOOR MUDGUARD SUB-ASSEMBLY (for Sport Package)