Home › Vehicle Interior › ENGINE HOOD / DOOR › SLIDE DOOR › 2013.04–2016.05
RM24M0E _58 Vehicle Interior _059569 ENGINE HOOD / DOOR _0292030 SLIDE DOOR A

ENGINE HOOD / DOOR  SLIDE DOOR  INSTALLATION  


PROCEDURE

Hide 68304B 1.INSTALL SLIDE DOOR HINGE ASSEMBLY CENTER LH

a.
B142298

Install the slide door hinge assembly center from the front part of the door rail.


Hide 2.INSTALL SLIDE DOOR

a.
B142296

Slide the slide door rearward and then install the slide door roller upper into the cutout of the door rail upper.


b.
B139488

Rotate the base of the slide door roller lower in the direction indicated by the arrow in the illustration and insert the roller lower into the cutout of the lower rail of the body.


c.
B139486

Install the door rail with the 3 bolts.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


d.
B139485

Install the wire with the clip.


e.

Connect the 2 connectors.


f.
B139484

Install the wire with the 2 bolts and 2 clips.

Torque:
7.8 N*m (80 kgf*cm, 69 in.*lbf)


Hide 68399 3.INSTALL SLIDE DOOR LOWER RAIL PLATE LH

a.
B139483

Install the rail plate with the bolt.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


Hide 68353 4.INSTALL NO. 2 SLIDE DOOR RAIL PROTECTOR PLATE

a.
B139482

Install the rail protector plate with the 2 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


Hide 67918E 5.INSTALL REAR DOOR SCUFF PLATE LH

Hide 76932A 6.INSTALL NO. 1 SIDE MUDGUARD BRACKET (for Standard)

Hide 7.INSTALL SLIDE DOOR MUDGUARD SUB-ASSEMBLY (for Standard)

Hide 76932A 8.INSTALL NO. 1 SIDE MUDGUARD BRACKET (for Sport Package)

Hide 9.INSTALL SLIDE DOOR MUDGUARD SUB-ASSEMBLY (for Sport Package)

Hide 10.INSPECT SLIDE DOOR PANEL SUB-ASSEMBLY LH

Hide 11.ADJUST SLIDE DOOR PANEL SUB-ASSEMBLY LH

Hide 12. PERFORM INITIALIZATION

a.

Perform initialization (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.