Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
1. DISCONNECT NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2.REMOVE SLIDE DOOR MUDGUARD SUB-ASSEMBLY (for Standard)
76932A
3.REMOVE NO. 1 SIDE MUDGUARD BRACKET (for Standard)
4.REMOVE SLIDE DOOR MUDGUARD SUB-ASSEMBLY (for Sport Package)
76932A
5.REMOVE NO. 1 SIDE MUDGUARD BRACKET (for Sport Package)
67918E
6.REMOVE REAR DOOR SCUFF PLATE LH
68353
7.REMOVE NO. 2 SLIDE DOOR RAIL PROTECTOR PLATE
Remove the bolt and rail protector plate.
68399
8.REMOVE SLIDE DOOR LOWER RAIL PLATE LH
Remove the bolt and lower rail plate.
9.REMOVE SLIDE DOOR
Remove the 2 bolts, 2 clips and bracket.
Disconnect the 2 connectors from the body side and remove the bolt, clip and wire.
Remove the 3 bolts and center hinge LH.
Slide the slide door panel towards the center of the vehicle, extract the slide door roller from the slide door rail center cutout and remove the slide door LH.
Rotate the base of the slide door roller lower in the direction indicated by the arrow in the illustration, and then remove the roller from the cutout of the lower rail from the body side.
68390A
10.REMOVE SLIDE DOOR HINGE ASSEMBLY CENTER LH
Slide the slide door center hinge towards the front of the vehicle, tilt it in the direction indicated by the arrow in the illustration and remove the hinge from the vehicle.