Home › Drivetrain › K112 (CVT) › CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM › 2013.04–2014.09
RM24M0E _52 Drivetrain _059572 K112 CVT _0292047 CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM L

K112 CVT  CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM  PRECAUTION  


NOTICE FOR INITIALIZATION


NOTICE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.


System Name See procedure
Lighting System (Click here)
Parking Assist Monitor System
Power Slide Door System
Power Back Door System


PRECAUTION


NOTICE:

Performing reset memory will clear the learned values of both the yaw rate (deceleration sensor zero point calibration) and CVT oil pressure (CVT oil pressure calibration). Make sure to perform reset memory, deceleration sensor zero point calibration and CVT oil pressure calibration when replacing any of the parts shown in the following table (See page Drivetrain>K112 (CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>INITIALIZATION).

Replaced Part
·

Continuously variable transaxle assembly

·

ECM

·

Oil pressure sensor

·

Brake actuator assembly (Skid control ECU) (w/o VSC)

·

Yaw rate sensor (w/ VSC)

·

Deceleration sensor (w/o VSC)




CAUTION:

When using compressed air, always aim away from yourself to prevent CVT fluid or kerosene from spraying on your face.


NOTICE:
·

Clean any sand, dirt or other foreign matter off of the transaxle before removal and disassembly in order to prevent contamination of the inside components.

·

Do not tilt the oil-pan side of the transaxle up until the oil pan is removed to prevent foreign matter from contaminating the inside of the valve body.

·

When disassembling light alloy parts such as the case, do not pry them with a screwdriver or similar tool. Instead, tap the parts with a plastic-faced hammer to separate them.

·

Do not wear cloth gloves or use cloth to handle parts during removal, disassembly, reassembly, or installation of the transaxle. Instead, wear synthetic gloves to prevent cloth fiber from entering the transaxle.

·

Disassembled parts should be arranged in order and care should be taken to prevent dust contamination.

·

Before reassembly, all parts should be cleaned, dried, and coated with Toyota genuine CVT Fluid FE. However, do not use alkaline cleaners to clean aluminum and rubber components. Also, rubber components such as O-rings, gaskets and oil seals should never be cleaned with solvents or gasoline under any circumstances.

·

Apply Toyota genuine CVT Fluid FE to all sliding surfaces and rotating parts.

·

Before installing O-rings and oil seal rings, coat them with Toyota genuine CVT Fluid FE and be sure not to damage them.

·

Do not clamp components in a vise without the use of protective aluminum plates.

·

Be careful not to damage the mating surfaces of components because damage to these surfaces can cause oil leaks.

·

Before applying sealant, remove all of the old sealant and thoroughly clean the surfaces with non-residue solvent.

·

Use of Toyota genuine CVT Fluid FE is recommended.