The ECM controls the secondary oil pressure calibration based on the secondary oil pressure signal detected by the oil pressure sensor.
| DTC No. | DTC Detection Condition
1.
Diagnosis Condition 2.
Malfunction Status 3.
Malfunction Time 4.
Other |
Trouble Area |
|---|---|---|
| P0841 | 1.
The requested oil pressure value is 0.5 MPa or less. 2.
The oil pressure sensor output value is 3.0 MPa or higher. 3.
3 seconds 4.
1 trip detection logic |
·
Oil pressure sensor ·
Continuously variable transaxle assembly ·
ECM |
| P2829 | 1.
The requested oil pressure value is 0.5 MPa or less. 2.
The oil pressure sensor output value is 3.0 MPa or higher. 3.
3 seconds 4.
1 trip detection logic |
|
1.
The vehicle is driven at a speed of 8 km/h (5 mph) or less with the shift lever in D. 2.
The ratio of the rotation speeds of the primary pulley (NIN) and secondary pulley (NOUT) exceeds the threshold. 3.
0.2 seconds 4.
2 trip detection logic |
The ECM checks for belt clamping high-pressure errors. When a mechanical malfunction is detected in the shift solenoid valve SLS and in the oil pressure sensor, the ECM detects the problem, illuminates the MIL and stores the DTC.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs using the tester.
| Result | Proceed to |
|---|---|
| Only P0841 and/or P2829 is output | A |
| P0841 and/or P2829 and other DTCs are output | B |
If any other DTCs besides P0841 or P2829 are output, perform troubleshooting for those DTCs first.
A
B
(See pageDrivetrain>K112 (CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>DIAGNOSTIC TROUBLE CODE CHART)
A
B
NEXT
NEXT
NEXT
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs using the tester.
| Result | Proceed to |
|---|---|
| P0841 and/or P2829 is output | A |
| DTC is not output | B |
A
B
NEXT
NEXT
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs using the tester.
| Result | Proceed to |
|---|---|
| P0841 and/or P2829 is output | A |
| DTC is not output | B |
A
B
NEXT
NEXT
NEXT