84540
1.ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY
Move the shift lever to N.
Remove the battery carrier support.
See the steps from Remove Radiator Cover Sub-assembly through Remove Battery Carrier Support (See page Drivetrain>K112 (CVT)>PARK / NEUTRAL POSITION SWITCH>REMOVAL).
Loosen the 2 bolts of the park/neutral position switch.
Align the protrusion with the neutral basic line.
Hold the switch in that position and tighten the 2 bolts.
| *a | Neutral Basic Line |
| *b | Protrusion |
Install the battery carrier support.
See the steps from Install Battery Carrier Support through Install Radiator Cover Sub-assembly (See page Drivetrain>K112 (CVT)>PARK / NEUTRAL POSITION SWITCH>INSTALLATION).
After the adjustment, perform the switch operation check (See page Drivetrain>K112 (CVT)>PARK / NEUTRAL POSITION SWITCH>ON-VEHICLE INSPECTION).