84540
1.INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
Install the park/neutral position switch assembly to the continuously variable transaxle.
Temporarily install the 2 bolts.
Install a new lock plate and the lock nut to the park/neutral position switch assembly.
Temporarily install the control shaft lever.
Turn the lever clockwise until it stops, and then turn it counterclockwise 2 notches.
Remove the control shaft lever.
Align the protrusion with the neutral basic line.
Hold the switch in that position and tighten the 2 bolts.
| *a | Neutral Basic Line |
| *b | Protrusion |
Using a screwdriver, bend the tabs of the lock plate.
Install the control shaft lever with the washer and nut.
Connect the park/neutral position switch connector.
33820B
2.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
Connect the transmission control cable to the control shaft lever with the nut.
Before connecting the transmission control cable assembly, check that the park/neutral position switch assembly and the shift lever are in neutral.
Install the transmission control cable to the transmission control cable bracket with a new clip.
74414D
3.INSTALL BATTERY CARRIER SUPPORT
74411
4.INSTALL BATTERY CARRIER
74431
5.INSTALL BATTERY TRAY
28800
6.INSTALL BATTERY
7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
53292A
8.INSTALL UPPER RADIATOR SUPPORT SEAL
84540
9.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
10.INSPECT SHIFT LEVER POSITION
11.ADJUST SHIFT LEVER POSITION