Home › Engine / Hybrid System › 2AZ-FE ENGINE CONTROL › ECM › 2013.04–2014.09
RM24M0E _51 Engine / Hybrid System _059541 2AZ-FE ENGINE CONTROL _0291792 ECM A

2AZ-FE ENGINE CONTROL  ECM  INSTALLATION  


PROCEDURE

Hide 89661 1.INSTALL ECM

a.
A132385

Install the 2 brackets to the ECM with the 4 screws.

Torque:
3.0 N*m (30 kgf*cm, 27 in.*lbf)


b.
A124572

Connect the 2 ECM connectors.

NOTICE:

When connecting the connector, make sure that dirt, water and other foreign matter do not become stuck between the connector and the other part.


i.

Connect the 2 ECM connectors and lower the 2 levers.

NOTICE:

Make sure that the 2 levers are securely lowered.




c.
A132384

Install the ECM with the 3 bolts.

Torque:
12.5 N*m (127 kgf*cm, 9 ft.*lbf)


d.

Connect the wire harness clamp.


Hide 17752 2.INSTALL NO. 2 AIR CLEANER INLET

a.
U188326

Insert the No. 2 air cleaner inlet to the No. 1 resonator, and then install the bolt.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 28800 3.INSTALL BATTERY

a.
A132382

Install the battery support, battery and battery insulator.


b.

Install the battery hold down clamp with the bolt and nut.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


c.

Connect the 2 wire harness clamps.


Hide 17700 4.INSTALL AIR CLEANER CASE

a.
A132379

Install the air cleaner case with the 3 bolts.

Torque:
7.0 N*m (71 kgf*cm, 62 in.*lbf)


b.

Connect the harness clamp.


Hide 85110 6.INSTALL COWL TOP OUTER PANEL WITH WINDSHIELD WIPER MOTOR AND LINK

a.

Install the cowl top outer panel with windshield wiper motor and link (See page Vehicle Interior>WIPER / WASHER>FRONT WIPER MOTOR>INSTALLATION).


Hide 28800A 7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 8.PERFORM REGISTRATION

a.

When replacing the ECM, perform vehicle stability control system recognition in ECM (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>REGISTRATION).


Hide 9.RESET MEMORY

a.

When replacing the ECM, perform the RESET MEMORY procedure (See page Drivetrain>U241E (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSAXLE SYSTEM>INITIALIZATION)(for U241E).


b.

When replacing the ECM, perform the RESET MEMORY procedure (See page Drivetrain>K112 (CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>INITIALIZATION)(for K112).


Hide 10.PERFORM INITIALIZATION

a.

Perform initialization (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting the cable from the negative (-) battery terminal.