Home › Drivetrain › K112 (CVT) › PARK / NEUTRAL POSITION SWITCH › from 2016.05
RM24M0E _52 Drivetrain _059572 K112 CVT _0292050 PARK / NEUTRAL POSITION SWITCH A

K112 CVT  PARK / NEUTRAL POSITION SWITCH  INSTALLATION  


PROCEDURE

Hide 84540 1.INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.

Install the park/neutral position switch assembly to the continuously variable transaxle.


b.

Temporarily install the 2 bolts.


c.
C070268

Install a new lock plate and the lock nut to the park/neutral position switch assembly.

Torque:
6.9 N*m (70 kgf*cm, 61 in.*lbf)


d.

Temporarily install the control shaft lever.


e.
C128920E02
2.823,0.74 2.969,0.927 0.146,0.188 10 true N 2.979,1.01 3.115,1.156 0.135,0.146 10 true R 2.958,1.375 3.115,1.542 0.156,0.167 10 true P

Turn the lever clockwise until it stops, and then turn it counterclockwise 2 notches.


f.

Remove the control shaft lever.


g.
C211792E02
2.099,0.546 2.272,0.696 0.173,0.150 10 *a 2.243,0.797 2.415,0.947 0.173,0.150 10 *b

Align the protrusion with the neutral basic line.


h.

Hold the switch in that position and tighten the 2 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

Text in Illustration
*a Neutral Basic Line
*b Protrusion


i.
C069814

Using a screwdriver, bend the tabs of the lock plate.


j.

Install the control shaft lever with the washer and nut.

Torque:
13 N*m (130 kgf*cm, 9 ft.*lbf)


k.

Connect the park/neutral position switch connector.


Hide 33820B 2.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Connect the transmission control cable to the control shaft lever with the nut.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)

NOTICE:

Before connecting the transmission control cable assembly, check that the park/neutral position switch assembly and the shift lever are in neutral.



b.

Install the transmission control cable to the transmission control cable bracket with a new clip.


Hide 74431 5.INSTALL BATTERY TRAY

Hide 53292A 8.INSTALL UPPER RADIATOR SUPPORT SEAL

Hide 84540 9.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY