Home › Engine / Hybrid System › 2GR-FE STARTING › ENGINE SWITCH › 2013.04–2016.05
RM24M0E _51 Engine / Hybrid System _059574 2GR-FE STARTING _0292071 ENGINE SWITCH A

2GR-FE STARTING  ENGINE SWITCH  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55420A 2.REMOVE INSTRUMENT CLUSTER FINISH PANEL CENTER ASSEMBLY

Hide 55414A 3.REMOVE INSTRUMENT CLUSTER FINISH PANEL END (w/o Navigation System)

Hide 4.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (for Navigation Receiver Type)

Hide 55660 5.REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55042B 6.REMOVE NO. 2 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY

Hide 55650 7.REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55041B 8.REMOVE NO. 1 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY

Hide 55474B 9.REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 89611 10.REMOVE ENGINE SWITCH

a.
A287162E01
0.996,1.49 1.960,1.650 0.965,0.159 10 Backside View

Disconnect the switch connector.


b.

Detach the 2 claws and remove the switch.