1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See Page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
85192
2.REMOVE FRONT WIPER ARM HEAD CAP
85221B
3.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH
85211B
4.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH
53867H
5.REMOVE FRONT FENDER TO COWL SIDE SEAL LH
53866J
6.REMOVE FRONT FENDER TO COWL SIDE SEAL RH
55781F
7.REMOVE COWL TOP VENTILATOR LOUVER
8.SEPARATE BRAKE MASTER CYLINDER RESERVOIR BRACKET
9.REMOVE FRONT COWL TOP OUTSIDE PANEL WITH WINDSHIELD WIPER MOTOR AND LINK
51442
10.REMOVE NO. 2 ENGINE UNDER COVER
53292A
11.REMOVE RADIATOR SUPPORT SEAL UPPER
16470
12.REMOVE RADIATOR RESERVOIR ASSEMBLY
28800
13.REMOVE BATTERY
74431
14.REMOVE BATTERY TRAY
15.REMOVE AIR CLEANER CAP SUB-ASSEMBLY
16.REMOVE AIR CLEANER CASE SUB-ASSEMBLY
17751
17.REMOVE NO. 1 AIR CLEANER INLET
17752
18.REMOVE NO. 2 AIR CLEANER INLET
74411
19.REMOVE BATTERY CARRIER
74414D
20.REMOVE BATTERY CARRIER SUPPORT
21.SUPPORT ENGINE
Support the oil pan with a jack, placing a wooden block between the oil pan and jack.
12372A
22.REMOVE ENGINE MOUNTING INSULATOR LH
12325A
23.REMOVE ENGINE MOUNTING BRACKET LH
Remove the bolt and engine wire bracket from the engine mounting bracket LH.
Remove the 4 bolts and engine mounting bracket LH from the automatic transaxle assembly.
84540
24.REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
Move the shift lever to the N position.
Remove the clip from the transmission cable bracket.
Remove the nut and transmission control cable assembly from the control shaft lever.
Disconnect the connector from the park/neutral position switch.
Remove the nut, washer and control shaft lever from the control shaft.
Remove the 2 bolts and park/neutral position switch from the control shaft.
Before removing the park/neutral position switch, remove any dirt or rust on the installation portion of the control shaft. Be sure to remove the switch straight along the shaft while being careful not to deform the plate spring that supports the shaft. If the plate spring is deformed, the park/neutral position switch cannot be reinstalled correctly.