Home › Drivetrain › U660E (AUTOMATIC TRANSMISSION / TRANSAXLE) › PARK / NEUTRAL POSITION SWITCH › from 2016.05
RM24M0E _52 Drivetrain _059579 U660E AUTOMATIC TRANSMISSION / TRANSAXLE _0292114 PARK / NEUTRAL POSITION SWITCH A

U660E AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See Page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 85192 2.REMOVE FRONT WIPER ARM HEAD CAP

Hide 85221B 3.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH

Hide 85211B 4.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH

Hide 53867H 5.REMOVE FRONT FENDER TO COWL SIDE SEAL LH

Hide 53866J 6.REMOVE FRONT FENDER TO COWL SIDE SEAL RH

Hide 55781F 7.REMOVE COWL TOP VENTILATOR LOUVER

Hide 8.SEPARATE BRAKE MASTER CYLINDER RESERVOIR BRACKET

Hide 9.REMOVE FRONT COWL TOP OUTSIDE PANEL WITH WINDSHIELD WIPER MOTOR AND LINK

Hide 51442 10.REMOVE NO. 2 ENGINE UNDER COVER

Hide 53292A 11.REMOVE RADIATOR SUPPORT SEAL UPPER

Hide 74431 14.REMOVE BATTERY TRAY

Hide 21.SUPPORT ENGINE

a.

Support the oil pan with a jack, placing a wooden block between the oil pan and jack.


Hide 12372A 22.REMOVE ENGINE MOUNTING INSULATOR LH

Hide 12325A 23.REMOVE ENGINE MOUNTING BRACKET LH

a.
C139835E04
1.073,1.583 1.323,1.583 1.323,1.583 2.073,1.927 true 0.896,1.5 1.052,1.667 0.156,0.167 10 true *1

Remove the bolt and engine wire bracket from the engine mounting bracket LH.

Text in Illustration
*1 Engine Wire Bracket


b.

Remove the 4 bolts and engine mounting bracket LH from the automatic transaxle assembly.


Hide 84540 24.REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.

Move the shift lever to the N position.


b.
C132237

Remove the clip from the transmission cable bracket.


c.
C161564

Remove the nut and transmission control cable assembly from the control shaft lever.


d.

Disconnect the connector from the park/neutral position switch.


e.
C136685

Remove the nut, washer and control shaft lever from the control shaft.


f.
C135732

Remove the 2 bolts and park/neutral position switch from the control shaft.

NOTICE:

Before removing the park/neutral position switch, remove any dirt or rust on the installation portion of the control shaft. Be sure to remove the switch straight along the shaft while being careful not to deform the plate spring that supports the shaft. If the plate spring is deformed, the park/neutral position switch cannot be reinstalled correctly.