Home › Drivetrain › AXLE › REAR AXLE HUB
RM24M0E _52 Drivetrain _059581 AXLE _0292140 REAR AXLE HUB A

AXLE  REAR AXLE HUB  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RH side and LH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See Page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 47750A 3.REMOVE REAR DISC BRAKE CALIPER ASSEMBLY

a.
A137317

Remove the 2 bolts and caliper.


Hide 42431 4.REMOVE REAR DISC

Hide 42440 6.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH

C136807

a.

Remove the 4 bolts, axle hub and bearing from the axle carrier.

NOTICE:

Do not place the hub and bearing's magnet rotor side so that it is facing downward, and do not allow the magnet rotor side to become damaged or contact foreign matter.