Home › Suspension › SUSPENSION › REAR SHOCK ABSORBER › from 2016.05
RM24M0E _53 Suspension _059582 SUSPENSION _0292145 REAR SHOCK ABSORBER A

SUSPENSION  REAR SHOCK ABSORBER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RH side and LH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 48540 1.INSTALL REAR SHOCK ABSORBER ASSEMBLY LH

a.
C133579

Fix the nut in place and tighten the bolt.

Torque:
58 N*m (592 kgf*cm, 43 ft.*lbf)

NOTICE:

Do not tighten the nut.



Hide 48530G 2.INSTALL REAR NO. 1 SHOCK ABSORBER CUSHION

a.

Install the cushion to the shock absorber.

NOTICE:

Make sure the cushion is securely fit into the groove of the body.



Hide 48530P 3.INSTALL REAR SHOCK ABSORBER CUSHION RETAINER

a.

Install the retainer to the cushion.


Hide 48750A 4.INSTALL REAR SUPPORT TO REAR SHOCK ABSORBER NUT

a.

Install a new nut.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)


Hide 48554A 5.INSTALL REAR SHOCK ABSORBER CAP LH

a.

Install the cap to the shock absorber.


Hide 64735G 6.INSTALL DECK TRIM SIDE SERVICE HOLE COVER LH

a.

Install the hole cover to the deck trim.


Hide 7.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 9.INSPECT AND ADJUST REAR WHEEL ALIGNMENT

a.

Inspect and adjust the rear wheel alignment (See page Suspension>SUSPENSION>REAR WHEEL ALIGNMENT>ADJUSTMENT).