Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
48258C
1.INSTALL REAR COIL SPRING INSULATOR LOWER LH
Install the insulator lower to the rear axle beam.
48231B
2.INSTALL REAR COIL SPRING LH
Align the stopper part of the insulator lower with the coil spring tip, and install the coil spring.
Install the coil spring so that there is 10 mm (0.39 in.) or less of clearance between the coil spring tip and insulator stopper part.
48259A
3.INSTALL REAR COIL SPRING INSULATOR UPPER LH
Align the stopper part of the insulator upper with the coil spring tip, and install the insulator upper.
Install the coil spring so that there is 10 mm (0.39 in.) or less of clearance between the coil spring tip and insulator stopper part.
48540
4.INSTALL REAR SHOCK ABSORBER ASSEMBLY LH
Slowly raise the rear axle beam with a jack, and connect the shock absorber to the rear axle beam.
Place a wooden or rubber block between the jack and arm.
Install the shock absorber with the bolt and nut.
Do not tighten the nut.
46430
5.INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY
46420
6.INSTALL NO. 2 PARKING BRAKE CABLE ASSEMBLY
89516
7.INSTALL SKID CONTROL SENSOR WIRE
8.INSTALL REAR WHEEL
9.STABILIZE SUSPENSION
10.CHECK SPEED SENSOR SIGNAL
11.INSPECT AND ADJUST REAR WHEEL ALIGNMENT
Inspect and adjust the rear wheel alignment (See page Suspension>SUSPENSION>REAR WHEEL ALIGNMENT>ADJUSTMENT).