Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › 2014.09–2016.05
RM24M0E _54 Brake _059583 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0292157 ANTI-LOCK BRAKE SYSTEM D

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  DIAGNOSIS SYSTEM  


DIAGNOSIS


a.

If the skid control ECU detects a malfunction, the ABS and/or brake warning lights will come on in order to warn the driver.


b.

The DTCs can be read by connecting SST (09843-18040) between terminals 13 (TC) and 4 (CG) of the DLC3 and observing the blinking pattern of the ABS warning light, or by using the intelligent tester (see page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR).


c.

This system has a sensor signal check function (see page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>TEST MODE PROCEDURE).



CHECK WARNING LIGHT


a.

Release the parking brake lever.

CAUTION:

Before releasing the parking brake lever, set chocks to hold the vehicle for safety.


HINT:

When the parking brake is applied or the brake fluid level is low, the brake warning light comes on.



b.

When the engine switch is turned on (IG), check that the ABS warning light and brake warning light illuminate and then turn off in approximately 3 seconds.

HINT:

If the warning lights do not illuminate, confirm whether the bulbs have burned out, and also check for a CAN communication system DTC, since the skid control ECU and combination meter are connected by the CAN communication line.

If the warning light remains on, perform the relevant troubleshooting procedures. The relevant troubleshooting procedures are instructed in the sections listed in the table below.

Section Title See procedure
ABS Warning Light Remains ON (Click here)
Brake Warning Light Remains ON (Click here)