If an ECM that is incompatible with the engine immobiliser system is installed, the ECM outputs this DTC.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B279C | When ECM that is incompatible with engine immobiliser system is installed. | ECM |
If the ECM is replaced, register the ECU communication ID.
Clear the DTCs (See page Vehicle Interior>ENGINE IMMOBILISER>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).
Recheck for DTCs.
B279C output does not recur.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for 2GR-FE) | B |
| NG (for 2AZ-FE) | C |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C