Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM › from 2016.05
RM24M0E _56 Audio / Visual / Telematics _059590 PARK ASSIST / MONITORING _0292203 PARKING ASSIST MONITOR SYSTEM T

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM  PROBLEM SYMPTOMS TABLE  


NOTICE:

The following inspection procedures for the parking assist monitor system are based on the assumption that the navigation system is normal. If the navigation system has any malfunctions, first proceed with troubleshooting the navigation system.


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



General
Symptom Suspected Area See page
When the shift lever is in R, the parking assist monitor image is not displayed (screen is not black). Navigation system (Reverse Signal Circuit) (Click here)
Navigation receiver assembly (Click here)
When the shift lever is in R, the parking assist monitor image is not displayed (screen is black). Image from Camera for Parking Assist Monitor is Abnormal (Click here)
Navigation receiver assembly (Click here)
When the shift lever is not in R, the parking assist monitor image is displayed. Navigation system (Reverse Signal Circuit) (Click here)
Navigation receiver assembly (Click here)

Display Malfunction
Symptom Suspected Area See page
Image from the camera for the parking assist monitor is abnormal. Image from Camera for Parking Assist Monitor is Abnormal (Click here)
Navigation receiver assembly (Click here)

Parking Assist Monitor System Malfunction
Symptom Suspected Area See page
Projected course guide lines are not displayed. Parking assist monitor screen display mode settings. (Check if the parking guide lines are set to off.) (Click here)
Navigation receiver assembly (Click here)
"System initializing" is displayed. Correct the steering angle neutral point (Click here)
"System initializing" is displayed even after correcting the steering angle neutral point. Steering sensor (Click here)
Correct the steering angle neutral point (Click here)
Steering angle setting (Calibration) (Click here)
Navigation receiver assembly (Click here)
"System not ready" is displayed. Parking assist monitor system initialization (Calibration) (Click here)
"System not ready" is displayed even after parking assist monitor system initialization. Navigation receiver assembly (Click here)
During parallel parking assist mode, the screen does not change even though the vehicle has moved. If the vehicle is reversing at very low speed, the screen may not change -
During parallel parking assist mode, the screen changes even though the vehicle has not moved. If the vehicle is stopped for extended period of time, the screen may change -
Guide lines and buttons are not displayed for all parking assist monitor screen display modes. Guide Lines and Buttons are not Displayed for All Display Modes (Click here)
The guide lines and buttons remain displayed even though the back door is open. CAN communication system (Click here)
Guide Lines and Buttons are not Displayed for All Display Modes (Click here)
When adjusting the camera optical axis, "Back door is open. Do not use the rear view monitor when the back door is not completely closed." is displayed even after the back door has been closed. Guide Lines and Buttons are not Displayed for All Display Modes (Click here)
"CHK" message(s) are displayed on the "Car Signal Check" screen. Car signal check (Diagnosis) (Click here)
When the parking assist monitor screen is displayed, the lines are misaligned. (The image from the camera is tilted.) Back camera position setting (Calibration) (Click here)