1. PRECAUTION
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55420A
3.REMOVE INSTRUMENT CLUSTER FINISH PANEL CENTER ASSEMBLY
55414A
4.REMOVE INSTRUMENT CLUSTER FINISH PANEL END (w/o Navigation System)
55522B
5.REMOVE RADIO TUNER OPENING COVER (w/o Radio Receiver)
6.REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type)
7.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (for Navigation Receiver Type)
55650
8.REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY (for RHD)
55041B
9.REMOVE NO. 1 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY (for RHD)
55660
10.REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY
55042B
11.REMOVE NO. 2 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY
55550
12.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
89340A
13.REMOVE CLEARANCE WARNING ECU
Disconnect the connector.
Remove the screw and ECU.